Furnace Repair & Installation in Staten Island, NY
- Hvac Contractor in Staten Island
- Central Air Conditioning Installation
- Air Conditioning Repair
- Boiler Repair & Replacement
- Included in a repair: full diagnostic, ignitor/flame sensor/blower checks, gas pressure and safety inspection, and the fix with the exact issue explained before work starts.
- Timing: most furnace repairs are handled in a single visit; a full furnace installation is typically scheduled within a few days once the unit is selected.
- Cost: repairs start at the $150 minimum charge; a new furnace installation runs into the low-to-mid thousands depending on size and efficiency.
- What we take: cash, major credit cards, and standard electronic payment.
- How to book: call (929) 725-2624 for a free on-site assessment and a written quote.
A repair makes sense when your furnace is under roughly 12–15 years old and the failure is a single component — a cracked ignitor, a dirty flame sensor, a failed blower motor, or a control board. These are common calls in older Victorian and colonial homes around St. George and West Brighton, where the furnace may be tucked into a tight basement corner near the water heater. If the unit still heats evenly and hasn't had repeat failures, fixing it is almost always the cheaper path.
Installation is the better choice when the furnace is past 15 years, the heat exchanger is cracked, or repair costs are climbing toward half the price of a new unit. Homes in Tottenville, Annadale, and Eltingville built in the 1980s and 90s often reach this point, and an older 80% AFUE furnace can be replaced with a high-efficiency 95%+ model that cuts gas use through Staten Island's long, damp winters. The trade-off is upfront cost: an installation is a larger investment, but it resets the clock, restores full warranty coverage, and usually lowers monthly heating bills.
Proper sizing matters more than most homeowners expect. A furnace that's oversized for a compact New Dorp or Stapleton row home will short-cycle, wear faster, and leave rooms unevenly heated. We measure the space and check ductwork before recommending a unit rather than matching whatever was there before. In larger Great Kills or Willowbrook houses, load and duct layout drive the correct capacity. Homes near Port Richmond with aging cast-iron radiators or converted duct systems get assessed for compatibility so the new furnace pairs cleanly with existing distribution.
Every visit begins with a diagnostic and a clear explanation of what's failing, so the repair-versus-replace decision is yours to make with real numbers. Gas connections and venting are inspected for safety on both repairs and installs, which is standard on Staten Island's older housing stock where flue and combustion-air conditions vary widely.
📞 Call (929) 725-2624Furnace Repair & Installation pricing in Staten Island
| Furnace diagnostic / minimum service call | from $150 |
| Common furnace repair (ignitor, flame sensor, thermostat) | $150–$450 |
| Blower motor or control board replacement | $450–$1,200 |
| New gas furnace installation (standard efficiency) | $3,500–$6,000 |
| High-efficiency furnace installation (95%+ AFUE) | $5,500–$9,000 |
Exact price confirmed free on-site before any work.
Furnace Repair & Installation — questions, answered
How fast can you repair a furnace in Staten Island?
Most furnace repairs in Staten Island are completed in a single visit. Common parts like ignitors, flame sensors, and thermostats are typically on the truck, so the fix happens the same day after the diagnostic.
Should I repair or replace my furnace in Staten Island?
Repair if your furnace is under about 15 years old and the fault is one component. In Staten Island homes with furnaces past 15 years, a cracked heat exchanger, or repair costs nearing half the price of a new unit, replacement is the smarter long-term choice.
How much does furnace installation cost in Staten Island?
Furnace installation in Staten Island typically runs from the low-to-mid thousands, with standard-efficiency units around $3,500–$6,000 and high-efficiency 95%+ models higher. The exact price is confirmed on-site after sizing and ductwork are checked.
Do you install high-efficiency furnaces in Staten Island homes?
Yes. High-efficiency furnaces are a strong fit for Staten Island's long heating season, and we install 95%+ AFUE gas units in neighborhoods like Annadale, Eltingville, and Great Kills after confirming duct and venting compatibility.
Is there a minimum charge for a furnace service call in Staten Island?
Yes. Furnace service calls in Staten Island start at a $150 minimum, which covers the diagnostic. That amount is applied toward the repair once you approve the work.